heitml Takes the World Wide Web to a Higher Level! (Give us your Email Address to receive the latest heitml news)

Introduction heitml Features Language Guide Language Reference The heitml Libraries Supported Platforms User Guide Download User Registration Discussion Group Mailinglist          NEW! heitml 1.2 new features Send us mail Contact Info

Supported Platforms Microsoft Internet Information Server (IIS)TM   General The ISAPI interface is a high speed interface of the IIS an should be preferred. All you need to do is to install the ISAPI version of heitml after installing the IIS. heitml will install only if the IIS is installed already. The heitml setup program will take care of everything else. Restarting the Server After Installation of heitml you need to restart the web server using the MS Internet Service Manager. Perform the following steps: Start the MS Internet Service Manager. Open the server for which you want to restart the WWW service. If the traffic light for WWW is green, click the right mouse button, choose 'Stop' and wait until the traffic light becomes red. Now the traffic light for WWW should be red. Click the right mouse button and choose 'Start'. After a while the traffic light should become green. Creating new Virtual Directories or Servers Using the MS Internet Service Manager, you can create new virtual directories and servers that are shown in the WWW. Creating virtual directories (roots) You want to add a virtual directory or server '/customer' and the directory on the hard disk is 'C:\customers\customer\wwwroot'. Perform the following steps: Start MS Internet Service Manager. Open the server for which you want to add the virtual root or server. If the traffic light for WWW is red, click the right mouse button, choose 'Start' and wait until the traffic light becomes green. Double-click on WWW, choose the 'Directories' Tab. Be sure that you checked the 'Enable Default Document' box and that the comma separated list in the 'Default Document' form field contains 'index.hei'. Click button 'Add'. In the Directory form field type in 'C:\customers\customer\wwwroot'. If you want to setup a virtual directory under your web server, click the radio button 'Virtual Directory' and then type '/customer' in the Alias form field. Be sure that the in the Access group box, the Read and Execute boxes are both checked. Click 'Apply' and 'OK'. Creating virtual servers You want to add a virtual server with IP address 'cus.tom.er.ip' and the directory on the hard disk is 'C:\customers\customer\wwwroot'. Perform the following steps: Start MS Internet Service Manager. Open the server for which you want to add the virtual root or server. If the traffic light for WWW is red, click the right mouse button, choose 'Start' and wait until the traffic light becomes green. Double-click on WWW, choose the 'Directories' Tab. Be sure that you checked the 'Enable Default Document' box and that the comma separated list in the 'Default Document' form field contains 'index.hei'. Click button 'Add'. In the Directory form field type in 'C:\customers\customer\wwwroot'. Click the radio button 'Home Directory', check the 'Virtual Server' box and type in the customer's IP address 'cus.tom.er.ip'). Note that you have to add this IP address to the TCP/IP protocol configuration with the Network application in Control Panel. Be sure that the in the Access group box, the Read and Execute boxes are both checked. Click 'Apply' and 'OK'. This page was dynamically generated by heitml © 1996-1997 H.E.I. All Rights Reserved